old forum


About the old forum category (1)
Folded double facade (4)
Big office building model (1)
Additional Strings and 3DChart issues (1)
Integrating integrated daylight and energy sim with Nat vent, light shelf, etc (2)
Honeybee Illuminance analysis FAIL (1)
Grizzly Bear: gbXML creation issue (1)
Hourly radiation value in the surface (1)
Results in Annual Daylight Simulation in Honeybee (1)
Outside Boundry Condition Object Problem (2)
UWG issues in Dragonfly (2)
The issue of indoor comfort map (1)
Different energy simulation results with same set up (1)
LB Radiation Analysis Out of scale Legend (1)
Order of the test points in the Honeybee Indoor View Factor Component (1)
Possible to use 3D chart to visualize totaled values from multiple HB Zones? (1)
Is it possible to simulate a chw-wc hvac system with honeybee (1)
Microclimate analisis on roof (1)
Design Flow Rate in ZoneMixing (2)
How to simulate Curtain Wall with Honeybee? (1)
Zone Division (1)
How to integrate ShadingControl to daylight simulation (2)
Doors in HoneyBee (1)
How do I render a baked analysis mesh? (1)
Solve adjacencies tolerance (1)
LB Sunlight Hours Analysis strange result and confusing output (2)
Renewable Energy Production Issue (7)
[clarified and updated] Sky View simulation results are strange when target building geometry is not included as part of the context (7)
Dragonfly issue with UWG component (13)
Optimization by custom algorithm in Honeybee (9)