Only one surface projecting DA

Hi everyone.

I would like to point out first that I’m pretty new to this, but I followed several tutorials and documents to try and solve the problem but I didn’t have any luck.

Basically I have 4 rooms and despite I placed windows on the rooms (made sure they are coplanar) but only one room is generating proper results. The others are entire same figure. File larger than 1.5mb, uploaded on Onedrive. Note that I am using Rhino 7 with 1.4.0 Ladybug (non-legacy).

Thank you in advanced for any help.


Annual Factor.gh (68.1 KB)

Hello, I have not opened the file, but I believe that the surfaces with an inconsistent result are simply turned to the wrong side, they look downwards. Check in Rhino in which direction the surfaces look and flip them.

Best regard

1 Like

That did the trick! Thank you for your help Liam.
One last question if I may. The results have such high results because of the large windows?
Thank you.