I read the relevant questions in the forum but could not find a solution to my problem.
I will be really thankful for any help.
I made all my geometry surfaces one by one by creat HBSrfs and setting all my airwalls in srfType, then made zones using creat HBZone.
I used honeybee separate zones by floor component and then solve adjacencies component afterward but
I still see my airwalls in ground floor are shown as interior wall as well.(kind of duplicate)
My roof and ceiling are not correct too.
due to this, when I run energy simulation I get many severe errors saying there is mismatch between vertex size and surfaces.
FINAL for question.gh (665.0 KB)
Can you please look into my file and help me with it?
THanks a lot