Move Ladybug Contour mesh

grasshopper ladybug-legacy
1

Hi,

I would like know if there is an option to set the base point for visualizing the results of a daylight simulation. I am using Ladybug Contour mesh and, differently from components like 3D chart, you can not move your visualization.
I would like to do this because I have set the analysis grid one over the other, and I would like to save an image of the two grids one next to the other at the same time.

Best regards,

Federico

2

@Federico587,

This should be totally possible.

  1. Save your results in a data component and internalize it
  2. Save your mesh in a mesh component and internalize it.
  3. Generate mesh using reColor Mesh component
    After doing this, moving the mesh should be quite possible.
1 Like
3

Why don’t you just move the final mesh using the Move component?

2 Likes