Black geometry in GH

[wim]

Hi @chris, all,
I got back from my long vacation yesterday and have been trying to look into this today.
Other people at support at McNeel have been looking into it previously and I’m also trying to find you if that has surfaced anything…

I’m confused though. I do see an issue where GH geometry gets clipped - which I think is what has just been reported in this thread:

Wired thing in Rhino6 with Ladybug

Hi everyone I found a really wired thing in Rhino6 when I use Ladybug, the result didn’t show(mesh) in rhino6 but when I did same thing in rhino5,it works.I put some picture to show I promble . dose it a bug in Rhino6? or I missed some things? thanks [r6] this is in rhino6(it dosen’t show compelet mesh) [r5] this is in rhino5(it works well)

In a perspective view, with certain angels, I can get the complete graph to be visible in RH6 but it gets clipped when I rotate to other angels.

Is that the issue that is being reported in this (“Black geometry”) thread?

I ran the gh file that was posted here …

Black geometry in GH

Here is my GH file which is surprisingly simple issue.gh (388.0 KB)

… on my hardware with (1) the Rhino version from before I left on vacation, then (2) updated Rhino, then (3) updated LB but never got it to display “Black geometry” as in the picture in that post.

So, at this point, I am wondering:

• are there 2 separate issues being discussed?
• are the display modes that cause the black geometry issue (wireframe and shaded were mentioned) factory-default modes?

Thanks for any clarifications!
wim