Hello everyone, first off a huge and hearfelt THANK YOU :smiling_face_with_tear: to everyone who contributed to making Fairyfly! I’m very excited about the new tool, which is why I tried it out as soon as possible. I’d like to offer some feedback from my first experience. Feedback #1 So far I have…

Thank you for digging into this and bringing this to my attention, @Gspahr . You are correct that something was going wrong here and I am nearly positive that I have figured it out. It seems there is a bug in THERM whenever there are two boundaries that use the AutomaticEnclosure radiation model, w…

Hi @Gspahr , Thank you for testing and for the feedback. You are right that I was so concerned about the inverse of this case (the Boundary line is shorter than that of any Shape segment) that I didn’t really consider the inverse (the Shape segment is shorter than the boundary line). I just added…

Thank you so much! The trick you proposed in the third point indeed does the trick beautifully: after a couple of tries it looks as if 20 is a good number for the Mesh Parameter. It did however shift the mesh to the right of the original geometries, not sure why. [image] As for the Display Pipeli…

Hi @Gspahr , I exposed the ability to change all of the mesh settings here: feat(therm): Expose Meshing Control on a dedicated component ladybug-tools:master ← chriswmackey:master opened 09:44PM - …

Thank you @chris , meshing options are working as intended. May take a little longer to simulate with a very fine setting like 50, but still, it’s very quick (it’s just a few seconds, but the resulting mesh can be a little intense to process). As for FF Color Boundary Attributes I wasn’t able to rec…

Hello @chris , it’s me again. I’m humbled by your comments, I just try to give my 2 cents whenever I can. And I would never even dream of calling any of your work a polished turd!! :sweat_smile: Turns out I’ve been playing around with THERM once again, trying to do a comparison between plain EPS vs …

Hi @Gspahr , I cannot recreate what you are describing here. When I simulate 0.25 meters thick of EPS (no foil), I get pretty reasonable temperatures: [image] When I put foil on both sides of the material with an emissivity of 0.5, I get pretty cold outdoor temperatures (as expected) but the res…

Hello @chris , thanks a lot. My rhino units were fine, I had already double-checked. But it seems I just found out the issue! Your gh definition indeed worked just like intended: [image] But then I noticed that the warm temperatures were on the right, and the cold ones on the left. I had done the…

[image] chris: If the error of a tenth of a degree or two keeps you up at night, I tested the updated version yesterday and I literally slept well last night, which means all systems are go! [image] chris: I can probably find a way to perform our own view factor calculation during transl…

Ladybug Tools | Forum

Fairyfly user feedback

grasshopper fairyfly

therm

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled