Thermal Comfort Analysis with different components (Honeybee Ground component)

1

Hello everyone,

I am trying to run a simple thermal comfort analysis.

I have a building and two surrounding surfaces.

I drew them in Rhino (surface à extrude surface)

In Hooneybee set them on Breps and turned them into rooms and then Ppugged them into the HB Ground component with a property. However, the HB Ground component appears red.

Does anyone have an idea, what might be the issue?

Thanks in advance

Ka_Le

Grasshopper
Grasshopper1288×640 63.5 KB

2

Hi.

The fault is not in HB ground, but the component uptream. It did not run, as can be seen by the color of it.

4

I found the mistake, i Just connected HB Ground with the “report” and not the “room”. Pretty easy mistake