'unrolling' radiation analysis results

Hello! I would like to ‘unroll’ the radiation results colored mesh, by face, like is seen below… of the surfaces the mesh is of.
I feel like I used to do this with the ladybug incident radiation analysis but I can’t seem to remember!
Thank you!

… perhaps I did not do this before… I always forget meshes are hugely different than srfs!

3 Likes

I wanted to post a similar question. Looking forward to the answer for your question :slight_smile:

2 Likes

Was an answer to this question ever found?? @TrevorFedyna @amraladdin