What is the Difference between estimate potential glare over the year and run daylight analysis (when it is connect to the glare analysis)

grasshopper honeybee-legacy
9

Thank you for the reply
1)So There is no component for doing daylight simulation for the kinetic shading right? I should each time fix an angle and do the simulation? it could not be done for different angles parametrically without fixing the angle.
I have seen in HB components named : "HONEYBEE ADVANCED DYNAMIC SHADING , what about this component is it helpful?

  1. You have told me that I should define it as a HBsurface (so as a normal geometry), so I have tried 2 methodes for define the kinetic louvers as shown in the following fig. method 1 is by using HB surfaces (yellow one), the method 2 is by using Masszones (red one)
    notice that this simulation is for daylight factor just as an example to told me if it is correct or not the simulation for the kietic shading

  2. do you have any tutorial related to doing simulation for kinetic shading using ?
    kinetic louvers daylight analysis.gh (92.7 KB)

image
image.jpg1629×847 560 KB

image
image.png1609×837 210 KB

image
image.png1867×1057 199 KB

Thank you
Best regards
Fatima.B