Your simulation did not run correctly because of the following error: Mesh generation error. Try simplifying the geometry near point or try increasing Quad Tree Mesh Parameter in Therm File Options.Calculation not successful

grasshopper honeybee-legacy
1

Hi all,

I have searched as much as I could to find a solution to this issue but I haven’t found a thread that addresses this. I can share a file as needed but what is the general idea behind this issue and what is a good approach to resolve it? The point that this error gives me is far away from my model.

image
image1397×472 139 KB

Thank you,
Georgios

2

I also have this problem I don’t know if you solved it .