Kia ora @Naga
Success!
I reverted to your original model.
That model did not have any context geometry. So I added Two blocks.
This may have been a result of this error message
This then was updated to match my current LBT installation 1.8.76 (running the Ladybug Sync operation)
AND
I replaced all the Eddy3D components with the latest 0.4.15.2 version one by one (I have left the older ones in place while testing
Then I was able to run the two EnergyPlus models (with and without AirFlow Network driven by wind pressures)
The right hand numbers are enhanced by the Wind Pressure Coefficients - why the heating EUI is lower there is a puzzle, but they ran! So now for the excitement of design exploration to explore this.
I attach the WIP of the updated file.
NOTE: I have here used your more complex building model in the gh file you distributed. I had in my original post incorporated a copy of what I had developed as the test of the Eddy3D template - trying to take baby steps from their simple blocks to what seemed your more complex demonstration.
Next step is my own geometry / model. I do like the fact that - if the data is generated by CFD, it remains available for all subsequent E+ runs
Thank you so much for this.
workflow_v1.0_Eddy0-4-15-2_LBT-1-8-76.gh (488.4 KB)