Honeybee failed Number to Mesh

[Hristo]

Hello all,

I tried to do a environmental analysis following some tutorials I found but I have a problem that haunts me. The last step, that converts the results to a mesh(recolor mesh command) doesnt seem to work. It says "Type conversion failed from Number to Mesh’. Also I cannot upload stuff as I am a new member, so I have no clue how to show you all what I get as a result

[tarun0949]

You can check the following discussions.

Daylight analysis error, The length of the analysis results list equals the number of mesh faces. Check your values list

Hello, I am trying to run grid based simulation on multiple meshes but it keeps giving an error of the length of the results. the file is here I already tried the flatten the results as Mustapha mentioned in a related question but no luck. any help with this would be appreciated. thanks

Recolormesh error the number of mesh

hi. I study daylight simulation. I have a error about recolormesh. everytime, this component say the same error message. if someone knows solution, please tell me about it. error-message is following {0;0;0} Current document units is in Meters Conversion to Meters will be applied = 1.000 length of the results [=1] is not equal to the number of mesh faces [=529] or mesh vertices[=576]. [recolormesh]

And also check this,

Ladybug Tools Forum Guidelines

[Hristo]

Thank you very much!